Aroma ARC-1000A Manuel d'utilisateur Page 251

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 254
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 250
tubes age 251
Overview of TV models from Roger Kennedy's site:
http://www.alltubetesters.com/articles/tester_guide.htm
The Military Models
Most all military testers utilized the Hickok circuit design. TV-2 series,
TV-3 series, TV-7, and TV-10 series. And the AN/USM-118A/B series Cardmatic
models as well.
The TV-2 is very good tester. Time consuming and a little complicated to
setup. All the parts were military grade and built for battle so the
testers are rugged. This is a very good tester if you don't mind the setup
procedure. The meter displays percent quality which is not direct Gm but
the actual Gm value can be obtained by the use of a chart or some basic
math calculations.
The TV-3 series are also good testers. They also contain a built in VOM
(volt ohm meter) which in today's environment is mostly useless. However, it
does display Gm directly and measures shorts/leakage to 300K ohms and has
three Gm range scales: 3000, 6000, 15,000
The TV-7 series is a good and popular tester. The meter displays in a
single numeric scale which can be directly converted to actual Gm by using a
chart or doing the math. This unit has up to 5 Gm ranges depending on the
model you obtain. The TV-7 D/U was the final model built and has the most Gm
ranges with the latest upgrades and best overall performance of the TV-7
series.
The TV-10 series is yet another good tester. The TV-3 and TV-10 are almost
identical except the TV-10 series does not have the built in VOM operation. This
unit measures directly in Gm.
The military cardmatics AN/USM-118A or B versions are the same as the
commercial Hickok 1234A or B version or the Western Electric KS-17xxxxxx L1
or L2 versions. The only difference is the military grade components and the
cost to make them, which the US taxpayers covered. This is an excellent tester
with a +/- 4% accuracy in readings when properly serviced and calibrated. You
do need to obtain, or punch the cards for the tubes you will be testing. The
meter reading is percent qualty but the tube reference manual that came with
the unit makes it easy to calculate the actual Gm test value. No knobs to switch
all operation set up by the tube test card you put in.
I sent him a TV-10 to be updated and calibrated, plus some solid state mods.
As he is a one-man operation, I was not in a hurry, and in a few months I
received a very nice TV-10 that I have used for many years now.
Vue de la page 250
1 2 ... 246 247 248 249 250 251 252 253 254

Commentaires sur ces manuels

Pas de commentaire